Power Hungry Performance Forum  

Go Back   Power Hungry Performance Forum > Power Hungry Performance Product Information > Gryphon Programmer (Disabled)

Gryphon Programmer (Disabled)
Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it.

If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here.


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #6  
Old Wed, December 15th, 2010, 01:10 PM
Jackpine's Avatar
Jackpine Jackpine is offline
PHP Groupie
 
Join Date: Nov 2008
Location: Among Elk, Deer and Javalinas on the Mogollon Rim in Aridzona
Posts: 3,243
Jackpine is a name known to allJackpine is a name known to allJackpine is a name known to allJackpine is a name known to allJackpine is a name known to allJackpine is a name known to all
Default

Quote:
Originally Posted by BigSur View Post
I wanted to follow up to this thread b/c I have a related question.

I have a small popup camper that weighs awround 1400 lbs.....I "think". I don't think I'm putting an extra 600lbs in to get over the 1 ton mark, but then again...I've never weighed my stuff.

I'm wondering if I should switch to my tow tune for this? My confusion is that my 87 performance tune has higher shift points and basically runs better overall than my tow tune, so I'd rather not change. I've towed once so far with the performance tune....no problems that I was aware of.
You should be fine. Popup campers are not too heavy, so I suspect your estimate is correct. In fact, the "tow limit" is in the 2000-2500# range. There's really no hard and fast rule here. If you were constantly climbing steep hills, I'd move that weight to the low side. On nearly level ground, you'd be fine towing more weight on a non-tow tune.

One thing I constantly recommend though, is to get your trailer and vehicle axles weighed at a truck weigh station. It is actually very easy to overload the rear axle on an f150, depending on the body style and what you put in the bed while you tow. The cost is nominal ($9.00 here in Tucson at the TTT truck stop) and you can position things on the scale so that you can get a separate weight for each axle. To be really safe, it would be good to get a separate weight of just the truck axles too, so you know how much the weight on each is increased. Ideally, you want the additional load on each axle to be the same.

- Jack
__________________

2024 F150 Platinum SCrew 3.5L PowerBoost FX4, Peragon Tonneau Cover, LineX Bed, 35% Window Tint on All Sides and Rear, Full Nose Paint Protection Film, Husky Mud Guards, Lasfit Floor Liners, VIOFO Dash Cam
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 04:46 AM.


All Contents Copyright 2008-2024, Power Hungry Performance