The kd4crs/Power Hungry/Gotts Mod (revisited - and with pictures)

lanemeyer · #1 Fri, February 20th, 2009, 10:46 PM

I think it has to do with the building codes in the area, no one carries the abs pipe.

Wow 100 HP that is amazing

***Jackpine*** · #2 Fri, February 20th, 2009, 11:14 PM

Quote:

Originally Posted by lanemeyer

I think it has to do with the building codes in the area, no one carries the abs pipe.

Wow 100 HP that is amazing

And, maybe by tomorrow it will be 200HP!

Like "fine wine"....

Got to get that picture!

- Jack

***88Racing*** · #3 Sat, February 21st, 2009, 06:45 AM

It's getting deep!

Lars

***Power Hungry*** · #4 Sat, February 21st, 2009, 07:55 AM

Time to get the waders on.... :waders:

***Jackpine*** · #5 Sat, February 21st, 2009, 07:29 PM

OK, here we are - the final "All Black" (apologies to the New Zealand Rugby team) version of my homemade CAI:

I compressed the bellows pretty much to give it some room to expand under engine torque and not pull the tube out of the fender wall. I noticed that earlier, when I had slid the bellows down the tube farther, it had pulled the tube out about 1/2 inch after a hard acceleration (because the engine twists away from the fender wall in this state).

Another view:

It's a fairly neat assembly, and even though the airflow curve is not as "smooth" as I'd like, I think it directs the flow fairly well.

- Jack

lynn2437 · #6 Mon, March 2nd, 2009, 12:28 AM

I understand why I need to unhook my battery, but for how long and also what terminal? I have reasearched alot on this mod and others like it and I'm getting conflicting times (from ten minutes to 24 hours) and differences on which terminal. I also read some where about turning on your lights or ignition or something to drain something? What does this mean.

Jack, Bill, anybody have clarifications for me?

Thanks,
Lynn

***Power Hungry*** · #7 Mon, March 2nd, 2009, 02:09 AM

ALWAYS... ALWAYS... ALWAYS... unhook the NEGATIVE battery cable first. There's not conflicting story on this, this is how it is and is basic Mechanics 101. There are two reasons for this:

1) If you are wrenching on the positive terminal and happen to bump the body or any other metal part of the vehicle or engine, you have an instant arc welder. Since nearly every car manufactured today is "negative ground", meaning that the the negative battery terminal is attached to the body, frame, and engine, if you were to accidentally short your wrench while undoing the negative cable, nothing will happen. If you short across the battery terminals... well, it wouldn't matter which side you are working at that point.

2) If you remove the positive battery cable and it should happen to touch the negative battery terminal or body, there is a chance that you could cause a sudden capacitive discharge in any of the onboard electronics which could damage them.

After removing the NEGATIVE battery cable, many people say to turn on the headlight switch in order to induce a drain to discharge any residual stored voltage in any of the electronics, including the PCM. Since in most cases there is already about 300-500 mA of current draw on the vehicle's systems, not to mention additional load from the dome lamps (if the doors are still open) and the hood lamp (if it's not broken), turning on the headlights won't hurt but probably isn't necessary. I've always let it sit 10-15 minutes, but seriously doubt anything over 30 seconds is necessary. Considering that the KAM (Keep Alive Memory) is akin to the memory presets of your radio, you'll find out in short order how long it takes to clear the PCM.

Hope this helps.