To check the injector circuits on the left side of the engine, put one lead of an ohmmeter to IDM pin 23 (Pink/Yellow). Then take the other lead and go to pin 22 (White), pin 7 (Brown/Light Blue), pin 19 (Light Green/Orange) and pin 9 (Light Blue). Each reading should be between 2 ohms and 5 ohms.
To check the injector circuits on the right side of the engine, put one lead of an ohmmeter to pin 24 (Orange), then place the other lead on pin 6 (Tan), pin 21 (Brown/Yellow), pin 8 (Tan/Black) and pin 20 (Tan/Red). Again, each circuit should read 2-5 ohms.
|
Sun, January 30th, 2011, 08:24 PM
Threaded Mode