Pending Gear change, new tune needed?

[Jackpine]

Originally Posted by jumpn

I'm hoping that my Gryphon can still be updated. I remember reading that PHP is not selling the model that i have anymore, but hopefully my calibration is still in their computers someplace.

If you had your Edge converted to a Gryphon before they stopped doing it (due to the cable problems), they will continue to support you. Your tunes are somewhere in their files. They'll just have to find them and put them on the Pegasus server.

You should make sure you are using the most current version of Pegasus now. Click on [Support]->[Downloads] on this page: Power Hungry Performance - Feed your hunger for POWER! to access the Pegasus download link.

- Jack

[jumpn]

Thank you, JackandJanet. Definately breathing a sigh of relief. I did download Pegasus again, so hopefully I'll be ready. I bought my Gryphon back in February of 2009 IIRC, so I'm sure Im good to go with their supporting it.

[Jackpine]

You MAY need to login to their Flashchat system and make sure Bill or Cody knows about this. Since I haven't seen any response from them in this thread, I doubt they are aware of your needs.

But, since you've downloaded Pegasus, start it up and plug your Gryphon into the PC. (Make sure you returned your truck to stock before removing the Gryphon.)

Then, when Pegasus shows that your Gryphon is connected, click on [Updates]->[Custom File Download]. If your custom files are still on the server, they will be found and you can go ahead and install them. This is worth a try and won't hurt anything if they're not there.

- Jack

[jumpn]

OK, will do. I totally would have forgot to return truck to stock!!! Thank you so much.

[jumpn]

Well, I think I'm set. Reset my truck to stock, connected Gryphon to my computer, followed directions, and it said it had updated.. I will reconnect to my truck later tonight and see what comes up.

[Jackpine]

Originally Posted by jumpn

Well, I think I'm set. Reset my truck to stock, connected Gryphon to my computer, followed directions, and it said it had updated.. I will reconnect to my truck later tonight and see what comes up.

I think you're good to go.

- Jack

[jumpn]

Looks and seems like everything went OK with file transfer and install last night. No issues this morning at all. My gear swap is happening in the first week of May, so I hope that it does all that it is supposed to do.