|
|
|||||||
| Phoenix Switch-On-The-Fly Chip (DISCOUNTINUED) (Disabled) Power Hungry no longer sells the Phoenix/TS chip, but if you need custom tuning we can recommend a few really good tuners that will be able to still provide tuning and support for your chip. If you have any other questions or comments about the Phoenix/TS chip, please post it here. |
|
|
Thread Tools | Display Modes |
|
#1
Wed, May 25th, 2011, 10:53 AM
|
|||
|
|||
PCM case getting hot
Just revieved my Phoenix chip on Monday. Hooked it up and everything runs great, like I have a brand new and much improved truck. The only thing I noticed was after driving for about 10 minutes I checked to make sure the chip was still attached firmly (which it was), but the outside of the PCM case seemed really warm.
I have to admit, I had never felt the PCM after driving prior to installing the chip so I have no idea if this is normal or not. So my question is is this normal? Or could something be hooked up wrong causing it to generate a lot of heat. Don't want to burn up my PCM or my new chip for that matter. Thanks. |
|
#2
Wed, May 25th, 2011, 11:15 AM
|
||||
|
||||
|
They get warm chip or no chip.
Normal operation.
__________________
Tuning, PCM flashing, and burning chips for 7.3s since 2008. Repairing all aspects of 7.3L Powerstrokes for 25 years. Eight 7.3L PSDs in the driveway including a 1994 Crown Vic and 1973 F100/2002 F350. Looking for the next victim. |
|
|
Linear Mode
