|
|
|||||||
| Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
|
Thread Tools | Display Modes |
|
#2
Wed, July 20th, 2011, 12:26 PM
|
||||
|
||||
In a nutshell:
1) Do not use jumper cables or charge the battery with the OBDII cable connected. 2) Always disconnect the OBDII cable when disconnecting the battery for any reason. 3) If you start noticing the device restarting overnight (meaning the device is on when you get in the truck in the morning) then this is a sign of a battery problem and should be addressed as quickly as possible. In the meantime, disconnect the device to avoid any further battery drain when the vehicle is off and also avoid any possible damage cause by the alternator spiking the electrical system to charge the weakened battery. The battery acts as a large capacitor and stabilizes the electrical system. If the battery is weak, it loses its effectiveness as a capacitor. 4) Always turn the key to the ON position BEFORE reconnecting the OBDII cable. This allows the programmer to identify the ECM correctly. (This goes for ALL programmers!) That's really about it. Enjoy! 
__________________
Bill Cohron - The Mad Doctor   Power Hungry Performance - The ORIGINAL in Ford performance tuning... Since 1997! (678) 890-1110 www.gopowerhungry.com - Home of the Hydra Chip, Minotaur Tuning Software, and the new Orion Reflash System for Navistar! Bring back  Windows™ XP and 7.  Windows™ Vista and Windows™ 8 is a pain in my a$$!  Windows™ 10 is only slightly less annoying!  Windows™ 11 is garbage!  Much to my surprise, I'm actually quite enjoying Linux! 
|
|
|
Threaded Mode