|
|
|||||||
| Phoenix Switch-On-The-Fly Chip (DISCOUNTINUED) (Disabled) Power Hungry no longer sells the Phoenix/TS chip, but if you need custom tuning we can recommend a few really good tuners that will be able to still provide tuning and support for your chip. If you have any other questions or comments about the Phoenix/TS chip, please post it here. |
|
|
Thread Tools | Display Modes |
|
#1
Wed, February 8th, 2012, 08:47 PM
|
|||
|
|||
SES after chip install.
My truck is setting a SES light when I switch to the stock or high idle position. What would cause this? It goes away if I switch back to any of the other positions. I have had my chip for about 2 weeks now and its done this 3 or 4 times. Thanks.
|
|
#2
Thu, February 9th, 2012, 10:03 PM
|
||||
|
||||
|
Quote:
You're using the same exact calibrations that hundreds of others are using (PMT1 standard calibrations)........  The ONLY thing it could be is that there is a code setting in a higher HP calibration where it's disabled and when you go back to stock (high idle is also a stock program), the code is no longer disabled and turns on the check engine light. If the engine doesn't stumble or stall, it's not a calibration problem. If you can find out what code is set, it would help. |
|
#3
Fri, February 10th, 2012, 05:05 AM
|
|||
|
|||
|
I'm thinking it might be the overboost code? It only seems to do it after I run the truck hard and then switch to stock or high idle. I'll have to see if my Autotap software can pull the code on this truck. If I can get the code I'll post it up. Thanks for the response!
|
|
|
Linear Mode
