|
|
|||||||
| The Conversation Pit This is where EVERYTHING else goes. No subject is too mundane. How's the weather in your area? Did your kid cut his first tooth? Really, what do you think about the President? And don't get me started on Cummins and Duramaxes. Have at it! |
 |
|
|
Thread Tools | Display Modes |
|
#1
Thu, May 7th, 2009, 11:49 PM
|
|||
|
|||
Torque Spec Question
I recently bought one of the (Ford 12 Bolt 10.25 & 12 Bolt 10.5 OEM Aluminum Differential Cove from Ford Motor Company) for my 2003 F350 Super Duty 4x4 with a single rear axle.
My question is what torque spec should I use to tighten the aluminum cover on the rear diff of my 03. I am sure it is different than the stamped steel one but am not sure what it is. 
|
|
#2
Fri, May 8th, 2009, 12:39 AM
|
||||
|
||||
24 ft. lbs. is the specification.
__________________
Tuning, PCM flashing, and burning chips for 7.3s since 2008. Repairing all aspects of 7.3L Powerstrokes for 25 years. Eight 7.3L PSDs in the driveway including a 1994 Crown Vic and 1973 F100/2002 F350. Looking for the next victim. |
|
#3
Fri, May 8th, 2009, 09:46 AM
|
|||
|
|||
|
Thanks
once again Cody you are the man.
 Thanks Joe
__________________
 2003 4x4 F350 Super Duty Crew Cab Short Bed4" Down pipe and exhaust, Wicked Wheel, Modified Exhaust Turbo Housing, Big Head Waste Gate Actuator, PML Transmission Pan, Factory Tech Valve Body, Autometer Gage Pod, PHP FU2 Chip |
|
|
|
Linear Mode
