|
|
|||||||
| F.U. Chip & FU2 Flex Chip (DISCONTINUED) (Disabled) If you have a question or comment relating the new F.U. Chip or FU2 Flex Chip, post it here. |
|
|
Thread Tools | Display Modes |
|
#1
Mon, September 21st, 2009, 06:35 PM
|
|||
|
|||
Dinging when first take off for about a mile! help!
I finally got my FU chip installed yesterday and I put the High idle 80hp daily 80hp light tow whisper mode 140 extreme and smoke show on it. My problem is when I first start the truck let it warm up it fine at idle it's fine but as soon as I go to take off I get a dinging like I left the key in the ignition with the truck off and the door open or left the lights on. There are no dash lights coming on and if I stop and let it go back to idle it will stop untill I take off again but after about a mile it will stop and not start back untill I cut the truck off and restart it. Anyone have this problem and if so what was the solution. Other than that I love the chip.
|
|
#2
Fri, February 5th, 2010, 06:42 PM
|
|||
|
|||
|
Check to make sure your park brake lever isn't sligthly depressed. The park brake light could be burned out and is not alerting you.
|
|
|
Linear Mode
