|
|
|||||||
| Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
|
Thread Tools | Display Modes |
|
#1
Sat, December 12th, 2009, 11:59 AM
|
|||
|
|||
gryphon 6.4 many problems.
I have a gryphon black magic serial gpfd64-0708. anyways i ama ford tech and i have a problem. i re-calibrated a 6.4 and the programmer will not work. it comes up with a calibration error 8u7acg needs update. so, whatever i download the software and update. everything seemed to be going fine. then it said it had a timeout on port 5 and it closed. now i re-try and it has a run time error 5 message when i go to the update screen. also i am a little worried because the ford calibration files are very new and according to the update manager it says the last update to the gryphon available calibration was 1/22/09. please help this customer is pissed.
|
|
#2
Thu, December 17th, 2009, 08:51 AM
|
||||
|
||||
|
I believe this issue is resolved. If there are no further updates, we'll close this over the weekend.
__________________
Bill Cohron - The Mad Doctor   Power Hungry Performance - The ORIGINAL in Ford performance tuning... Since 1997! (678) 890-1110 www.gopowerhungry.com - Home of the Hydra Chip, Minotaur Tuning Software, and the new Orion Reflash System for Navistar! Bring back  Windows™ XP and 7.  Windows™ Vista and Windows™ 8 is a pain in my a$$!  Windows™ 10 is only slightly less annoying!  Windows™ 11 is garbage!  Much to my surprise, I'm actually quite enjoying Linux! 
|
|
|
Linear Mode
