Hello From south GA
i have a 2003 ford f250 6.0 psd lariet,fx4. it has an EGR delete and 5" turbo back exaust. I installed the edge evolution on friday 09/0911. as soon as i programmed it to the computer it gave me 4 DTC (PO271),(PO272), (UO306) and(PO603). i was hisitant about it so i set it back to factory tune and removed the programmer. now it is running rough, hard starts,will only rev to 2000RPMS with a little white/blue smoke. i tried to drive it down the road to see if it would clear up but seemed to get worse. so i have been searching the web and i decided to check the voltage on my FICM (which is new) it is 48.8 volts with key on and 48.5 volts running, everyone is telling me thats good. my ? is when i removed the programmer is there anyway that it deleted the tune in the ficm or what could it be have you heard anything like this before and is it possible that all i will have to do is send you the ficm to retune it or is this gonna be one of those exspensive dealership things. if there is anyway you can email me back or give me a call. PLEASE 678 347 6126.Rusty. PHP forum strokin03.
|
Sun, September 11th, 2011, 09:59 PM
Linear Mode
