![]() |
|
Minotaur Automotive Tuning Software Tune your own 7.3L Diesel! If you have a question or comment about Minotaur? Post it here. Also, check out our Facebook group: Facebook - Minotaur Tuners |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
![]()
If you turn the EBP sensor off in the program, the PCM uses MAP instead. That what the YEBP switch is for.
__________________
Bill Cohron - The Mad Doctor ![]() ![]() ![]() Power Hungry Performance - The ORIGINAL in Ford performance tuning... Since 1997! (678) 890-1110 www.gopowerhungry.com - Home of the Hydra Chip, Minotaur Tuning Software, and the new Orion Reflash System for Navistar! Bring back ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Much to my surprise, I'm actually quite enjoying Linux! ![]() |
#2
|
||||
|
||||
![]()
Where the heck is the YEBP? And when I find it how do I turn it off?
|
#3
|
||||
|
||||
![]()
If you go to the top toolbar and select "level" and "genius", go into parameters (if you've never seen parameters in "genius" level.....get ready!).
"YEBP" is going to be in the top 1/4 of listed parameters somewhere. "1" is on. "0" is off. Good luck!
__________________
Tuning, PCM flashing, and burning chips for 7.3s since 2008. Repairing all aspects of 7.3L Powerstrokes for 25 years. Eight 7.3L PSDs in the driveway including a 1994 Crown Vic and 1973 F100/2002 F350. Looking for the next victim. |
#4
|
||||
|
||||
![]() Quote:
I have and its scary. ![]() Ok, I wont leave it in "genius" for too long, it just takes to long to get around. Thanks I will give that a try. |
![]() |
|
|