![]() |
|
Minotaur Automotive Tuning Software Tune your own 7.3L Diesel! If you have a question or comment about Minotaur? Post it here. Also, check out our Facebook group: Facebook - Minotaur Tuners |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
![]()
It defiantly seems like it tries to shift.
I couldn't find the target slip time, I read that in another post but couldn't find it. I did raise the TV pressure and it helped a little on the 1-2 shift but it still isn't right.
__________________
96 7.3L E4OD, Ext. Cab 22x,xxx miles Intake, Exhaust, 6.0L IC, 4 Wheel Disc Brakes. Dana 60, Electric Fuel, SD HPOP, 6" Miter cuts, 3" plenums Rosewood Stage IIs, Built tranny. Minotaur with some tunes from Bill ![]() Planning: Traction bars, HPOP, Nitrous?? Last edited by 907DAVE; Fri, April 1st, 2011 at 05:57 PM. Reason: I made a bo-bo. |
#2
|
||||
|
||||
![]()
Sorry bout that......
![]() I just realized you are playing with an OBS....target slip time must not be an option for ya. |
#3
|
||||
|
||||
![]()
Dang, any other ideas? All i really see the could speed up the shifts are the TV tables
__________________
96 7.3L E4OD, Ext. Cab 22x,xxx miles Intake, Exhaust, 6.0L IC, 4 Wheel Disc Brakes. Dana 60, Electric Fuel, SD HPOP, 6" Miter cuts, 3" plenums Rosewood Stage IIs, Built tranny. Minotaur with some tunes from Bill ![]() Planning: Traction bars, HPOP, Nitrous?? Last edited by 967.3L4x4; Fri, April 1st, 2011 at 07:42 PM. |
#4
|
||||
|
||||
![]() Quote:
__________________
F250 Reg Cab - 1,172 HP / DJ# / 11.56 Fuel Only / 10.94 Nitrous / Dyno Run 10-2009 -------------------------------------------------- Wide Open Performance - Engine, Chassis Build Swamps Diesel Performance - Injectors & IDM Gearhead Automotive Performance - Stage II Cam |
#5
|
||||
|
||||
![]() Quote:
Thanks John
__________________
96 7.3L E4OD, Ext. Cab 22x,xxx miles Intake, Exhaust, 6.0L IC, 4 Wheel Disc Brakes. Dana 60, Electric Fuel, SD HPOP, 6" Miter cuts, 3" plenums Rosewood Stage IIs, Built tranny. Minotaur with some tunes from Bill ![]() Planning: Traction bars, HPOP, Nitrous?? |
#6
|
||||
|
||||
![]()
Baby steps......
Start on the low side of your shift pressures and creep up to it. This is something that will take a bit of time and patience to get perfect. |
#7
|
||||
|
||||
![]()
ok thanks, I think all I hve with my OBS is pressure tables to control the firmness. Ill either have a shift kit or a VB installed end of next week, should be fun.
__________________
96 7.3L E4OD, Ext. Cab 22x,xxx miles Intake, Exhaust, 6.0L IC, 4 Wheel Disc Brakes. Dana 60, Electric Fuel, SD HPOP, 6" Miter cuts, 3" plenums Rosewood Stage IIs, Built tranny. Minotaur with some tunes from Bill ![]() Planning: Traction bars, HPOP, Nitrous?? |
![]() |
|
|