@ Dave
I set both of them the same. I was only using that particular definition for example. I have the problem with 1-2 2-3 3-4 and down shifts too. The trouble is when I try to adjust my down shifts I'm just shooting in the dark since none of the mph correspond to any of the shift points. Because of this it takes multiple times to figure out what mph a point is at. Also, its not 10mph across the board difference. Its gets smaller as the speeds lower, its not a constant.
@ Cleatus
Why do you think it makes no difference when I change my tire size rpm? I would think that should do something?
|
Tue, July 26th, 2011, 08:50 AM
Threaded Mode