Ok I just went outside and tried it. I turned the ignition to the ON position, plugged the Gryphon into the diagnostic port, the unit power up and I pressed enter then it showed me my .hex file. I went to press enter again and nothing happened. Usually the buttons have a sound when you press them but once I press enter after it shows my .hex file name, the button sounds go away. Also I didn't mention this before, when I turn the ignition to the off position the programmer doesn't go off. I've included a pic of what the screen looks like when you look directly at it. I've been taking pics from about a 45 degree angle.
|
Thu, November 10th, 2011, 11:13 AM
Threaded Mode