I'm not going to be much help either. The only time I've heard of the "trying to bridge" notification is when the Gryphon is plugged into a PC and has just finished updating the firmware. Bill has said the "bridge" is the communications circuit built into the OBD-II cable for the older vehicles (up to 2003).
Is yours a pre-2004 truck? And, to repeat Lars, did you have the ignition ON before plugging the Gryphon in?
If you answered YES to the first three questions Lars asked, I suspect the problem will have to be handled by Bill or Corey.
- Jack
__________________
2024 F150 Platinum SCrew 3.5L PowerBoost FX4, Peragon Tonneau Cover, LineX Bed, 35% Window Tint on All Sides and Rear, Full Nose Paint Protection Film, Husky Mud Guards, Lasfit Floor Liners, VIOFO Dash Cam
|
Sun, April 5th, 2009, 12:29 AM
Threaded Mode