|
|
|||||||
| Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
|
Thread Tools | Display Modes |
|
#16
Wed, April 8th, 2009, 08:12 PM
|
||||
|
||||
No, what your brother put into the PCM should not have any effect if you correct it using the Gryphon.
So OK, now you have much smaller tires on all axles. I see them as having an unloaded diameter of about 30.5 inches. With no squish, the circumference is 2434mm. With a 7% rubber squish (what I'd start with), the value you should enter for Tire Size is 2364mm. Remember to hit <Enter> after you do that, then scroll to "Done" and hit <Enter> again to start programming. - Jack |
|
|
Threaded Mode