some ???

***cleatus12r*** · #1 Mon, January 25th, 2010, 07:37 PM

Thanks, Joe.

epowers777,

You can have any three programs you would like on the Gryphon and they can be changed at any time you desire as long as you contact Bill and tell him what you want changed.

As for the cutting of fuel for slippage thing, I don't know for sure how that works. I would have to tell you to do some research on the Edge Evolution (new generation) for your truck and you will find your answer. I don't have time to do it now since I have a fire department meeting in a little bit and I have to eat.....dang necessities in life anyway.

Good luck!

epowers777 · #2 Tue, January 26th, 2010, 04:40 AM

Ok If I get the fu chip would I be able to pass smog inspection if I get picked. I live in Northern california and heard there starting to smog our truck I read how to do it with the gryphon how would you do it with the fu chip.Would I have to have a stock setting on it?
Also thank you very much for your help!!

epowers777 · #3 Tue, January 26th, 2010, 08:16 AM

Also can I run bio diesel outa the gas pump with these tunes. I get mine from a propel station in rocklin ca

Diesel Rookie · #4 Tue, January 26th, 2010, 02:30 PM

I run B100 in my truck with the tunes all the time in the summer and it runs fine. There is a very minor difference in power and fuel economy but it has never hurt anything. I asked Bill about this once and he said it was not a big deal. He did say he could write some custom BD tunes but needs to know the source of the oil, corn, conala, pnut, etc.

As for the stock thing you can just pull the chip out and it will go back to stock. Cody correct me if I am wrong but the chip just overides the trucks computer it does not actualy put anything on it.

I also am in CA and have not ever been approached on smog. If you are ever in the Sunnyvale Area (San Jose) and want to see how the tunes are in my truck let me know I would be more than willing.

Joe

epowers777 · #5 Tue, January 26th, 2010, 05:43 PM

I live in foresthill above roseville. Thanks for the offer if im down there that would be cool. I was told its betterto run biodiesel is that true? do you loose fuel economy? And how do you like your wicked wheel?

ChuckD · #6 Tue, January 26th, 2010, 06:14 PM

Here in AZ they do an opacity test. I went through earlier this month and passed with no problems. I left it on my performance tune and blew a 5 out of an allowed 40. The didnt plug into my OBDII port.

***cleatus12r*** · #7 Tue, January 26th, 2010, 06:50 PM

The really attractive thing about running a chip on the 7.3L vs. running a flash programmer is that there is no P1000 code left behind (common of reflashing to stock) that will cause a "retest" situation for emissions. Removing a chip will only set a P0603 code that generally will not cause an emissions failure (unless you get some over-the-top inspector that knows nothing). What will cause problems are the actual trouble codes that have been set while running a chip (overboost, low ICP, etc.) or if there are actual problems with the truck.

You are right Joe, nothing is "left behind" when the chip is removed, except codes relating to actual problems. If you clear the codes, you will get a P1000 code that will require you to drive around for a while and then retest.

If there is no physical inspection of the truck, just an opacity test and scan test, you may be able to get away with testing with chip in....just set it to the lowest setting and run it.